2005 ic ce

3 Active Recalls Safety Report

Is your insurance coverage up to date?

Recalls can affect vehicle value and safety ratings.

Check Rates →

Safety Recall

#10V103000

RELEASE OF THE PARKING BRAKE MAY CAUSE SUDDEN, UNEXPECTED SHIFT IN VEHICLE POSITION POSSIBLY RESULTING IN PROPERTY DAMAGE, PERSONAL DAMAGE, OR DEATH.

Technical Summary NAVISTAR HAS NOTIFIED NHTSA ABOUT A DEFECT IN CERTAIN MODEL YEAR 2010 AND 2011 IC CE, BE, AND FE SCHOOL BUSES MANUFACTURED FROM NOVEMBER 19, 2003 THROUGH FEBRUARY 9, 2010. THE PARKING BRAKE MAY RELEASE IF THE BRAKE SYSTEM ELECTRONIC CONTROL UNIT SOFTWARE MISINTERPRETS INPUT SIGNALS GENERATED FROM CYCLING THE IGNITION SWITCH MORE THAN ONCE AT A SPECIFIC FREQUENCY.

Safety Recall

#10V267000

THIS INCREASE TO HIGH IDLE SPEED MAY OCCUR WITHOUT WARNING CAUSING A SUDDEN AND UNEXPECTED SHIFT IN VEHICLE POSITION POSSIBLY RESULTING IN PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH.

Technical Summary NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2003 THROUGH 2010 INTERNATIONAL TRUCKS AND IC COMMERCIAL BUSES MANUFACTURED FROM DECEMBER 4, 2001 THROUGH DECEMBER 14, 2009 EQUIPPED WITH INTERNATIONAL VT365 ENGINES HAVING ENGINE CALIBRATION PAN2PVR0, PAN2PVR1, OR PAN2PWR. THE ENGINE NORMALLY RESPONDS TO A FAILED OPEN ACCELERATOR POSITION SENSOR CIRCUIT FAULT BY RETURNING THE ENGINE TO LOW IDLE SPEED OF 800 RPM AND DISABLING THE DRIVER'S ABILITY TO INCREASE THE ENGINE SPEED. HOWEVER IF THE OPEN CIRCUIT CORRECTS ITSELF WITHIN 30 SECONDS OF INITIATION, ENGINE SPEED COULD SUDDENLY INCREASE TO A HIGH IDLE SPEED OF 1200 RPM.

Safety Recall

#15V772000

If the bearings move out of position, the stowed platform may have excessive movement resulting in failure of the platform mounting. This failure could cause the wheel chair lift platform to fall out of the vehicle when the doors are opened, increasing the risk of injury for the lift operator.

Technical Summary Kingmor Supply, Inc. (Kingmor) is recalling certain model year 2005-2017 IC CE school buses manufactured September 1, 2005, to May 1, 2017, and modified to be equipped with certain model S2005, S2010, S5005, S5010, S5505, and S5510 wheelchair lifts built by the Ricon Corporation. The affected lifts are equipped with folding link arms that may have pivot holes that are too big, allowing the bearings to move out of position.